Anchor Connector-PG30-Oblique (Model P)
This anchor connector allows 2 PG30 extrusions to be connected together at an angle other than 90?°. It requires some machining to use, specifically:
A 12mm hole, 21mm deep and 30mm from the end of the extrusion (measured from centre of extrusion is cut at an angle). See the T-Slot primer in the resources section for more detailed information and pictures.
Product Specifications
| Look-up Reference | |
|---|---|
| Catalogue Page | 50 |
| Manufacturer Part Number | 3.11.30.04 |
| Physical Properties | |
| T-Slot Profile Size | PG30 |