Anchor Connector-PG40-Oblique (Model P)
This anchor connector allows 2 PG40 extrusions to be connected together at an angle other than 90?°. It requires some machining to use, specifically:
A 15mm hole, 27mm deep and 32mm from the end of the extrusion (measured from centre of extrusion is cut at an angle). See the T-Slot primer in the resources section for more detailed information and pictures.
Product Specifications
| Look-up Reference | |
|---|---|
| Catalogue Page | 53 |
| Manufacturer Part Number | 3.11.40.04 |
| Physical Properties | |
| T-Slot Profile Size | PG40 |