Hollow Shaft Optical Encoder IHC3808
Note: The 3532_1 is the same as the 3532_0, except this revision has a 5-pin connector soldered to the end of the cable so it can be plugged directly into a Phidgets encoder interface.
This sturdy optical quadrature encoder can be attached to the 8mm rear shaft of a motor without need for a shaft coupler. It has 360 counts (full quadrature cycles) per rotation and can be installed easily by fitting it over the shaft and tightening the set-screw. This encoder makes use of the index channel, sending one pulse for every full rotation.
Comes Packaged With
- Mounting screws and washers
Product Specifications
Encoder Properties | |
---|---|
Output Circuit Type | Push-Pull (Single-Ended) |
Controlled By | Encoder Interface |
Encoder Resolution | 360 CPR |
Encoder Speed Max | 4500 RPM |
Electrical Properties | |
Supply Voltage Min | 5 V DC |
Supply Voltage Max | 5 V DC |
Output Frequency Max | 100 kHz |
Physical Properties | |
Shaft Diameter | (Inner) 8 mm |
Shaft Maximum Axial Load | 10 N |
Shaft Maximum Radial Load | 20 N |
Operating Humidity Min | 30 %RH |
Operating Humidity Max | (Non-condensing) 85 %RH |
Operating Temperature Min | -10 °C |
Operating Temperature Max | 70 °C |
IP Rating | IP54 |
Weight | 121 g |
// <![CDATA[
$(document).ready(function() { // Toggle discount pricing on product page if($('#ph-j-price-table tbody tr').length > 4) { $('#ph-j-price-table').append('
// ]]>